One of the best ways to clean a rug with less water and more time is by using a plunger. Place the plunger over the dirty area and push and pull until the dirt and water are forced onto the plunger. carpet cleaning sydney

Use a vacuum cleaner to suck all of the liquid out of the rug, then sprinkle some baking soda over it to help hold it together. Finally, use a heat gun to dry off the area.

Use a vacuum cleaner.

Another great way to clean a rug with less water and more time is by using a vacuum cleaner. Make sure you have enough suction power to suck all of the liquid out of the rug, then set up your vacuum cleaner in an upright position and turn on the suction power. Use one or two passes per side on each part of the rug, making sure not to get too close to any sharp edges or fabric lines. Finally, sprinkle some baking soda over the area to help hold it together.

Use a mop

If you’re short on time but don’t want to use water or vinegar, you can try using a mop instead. Wet your hands first, then place them over the dirty areas of your rug andmop them until they’re completely wet (but not sopping wet). Then place your towel on top of that andmop again until it’s completely dry (but not sopping wet). Repeat as needed until everything is cleanly cleaned.

Conclusion


Cleaning a rug with less water and more time can be a lot easier than you might think. By following some helpful tips, you can achieve great results in little time.